Storing remote codes:
The codes of up to three transmitters can be read into the memory of the remote control receiver unit. (If a fourth code is stored)
NOTE: It is important to adhere to time limits between steps.
1. Turn the ignition switch ON (II).
2. Within 1 to 4 seconds, press the lock or unlock button on the transmitter while keeping it pointed at the receive control unit.
3. Within 1 to 4 seconds, turn the ignition key to the OFF position.
4. Within 1 to 4 seconds, turn the ignition key to the ON position
5. Within 1 to 4 seconds, press the lock or unlock button on the transmitter while keeping it pointed at the receive control unit.
6. Within 1 to 4 seconds, turn the ignition key to the OFF position.
7. Within 4 seconds, turn the ignition key to the ON (II) position
8. Within 1 to 4 seconds, press the lock or unlock button on the transmitter while keeping it pointed at the receive control unit.
9. Within 1 to 4 seconds, turn the ignition key to the OFF position.
10. Within 4 seconds, turn the ignition key to position ON (II)
11. Within 1 to 4 seconds, press the lock or unlock button on the transmitter while keeping it pointed at the receive control unit.
12. Check for the sound of the door lock actuators. Within 1 to 4 seconds, press the lock or unlock button on the transmitter again.
13. Within 15 seconds, aim the transmitters (up to three) whose codes you want to store at the receiver and press the lock or unlock buttons on the transmitters.
Check that you can hear the sound of the door lock actuator after storing each transmitter code.
14. Turn the ignition key to the OFF position and remove the key.
15. Check that the operation is correct with the new code (s).